Sukkah Card Box

3D print for the Sukkos flashcardsSukkah Card Box

A sukkah sized to your cards. Enter how many cards are in each deck, pick the walls, the inside, and the schach, watch it update, then download the STL files for exactly that box. The schach slides in from the front on dovetail rails, so it stays put when the box is carried or tipped.

Drag to rotate, scroll or pinch to zoom

Cards in each deck (0 leaves a deck out)

Decks

Wall boards
Build

Inside
Schach
Colors

Sample cards · tap to flip

Printing it

Orientation and settings

  • The box prints upright, exactly as it stands. The lid prints flat with the schach facing up.
  • 0.4 mm nozzle, 0.2 mm layers, 10 to 15 percent infill. PLA is fine. Two walls is enough for the light build.
  • To use less plastic: choose the Light build, Open slats, and Palm fronds. Then measure your real cards, since a thinner stack makes a shorter box. The estimate under the Build switch updates as you choose.
  • Use 0.2 mm layers, not adaptive layer height. The lid rails and other slopes are cut in 0.2 mm steps so they print as smooth 45 degree bevels. Keep elephant-foot compensation on, since the lid's first two layers are the rail edge.
  • No supports. The rails, plank edges and doorway corners are stepped at 45 degrees so they print in the air on their own.
  • Everything fits a 180 mm bed.

Card sizes

  • The card size comes from how the flashcard page printed them. Pick the same card size here. The two "fills the sheet" sizes also depend on the paper and on gaps, so pick those too. The 2.6 x 3.25 and poker sizes are the same on every paper. If you trimmed the cards, choose Custom size and type what a card measures.
  • The box adds 4 mm of width and 5 mm of finger room above the cards.
  • The box depth comes from your card counts. The starting numbers are the three decks as printed: Mishnayos 113, General 144, and Bochurim 74. Change them if you pull cards out or add more.
  • Measure your cards. Stack 20 of them, squeeze lightly, and measure the stack. Card stock varies a lot, and the starting value of 7 mm is the thick end on purpose, so the box is never too small.
  • Each section adds 15 percent plus 4 mm of slack, so cards can tilt and be flipped through.

Two colors with an AMS

  • Each part comes as two files that share the same position. Import both files of a part together and answer Yes when the slicer asks to load them as one object with multiple parts. Then give each part its filament.
  • Box: planks in one color, corner posts and door frame in a second. Lid: wooden frame in one color, schach in green.
  • The box posts run the full height, so a two-color box changes filament on every layer. That adds hours and purge waste. The two-color lid is cheap: only the top few millimetres change color.
  • No AMS? Print the one-color files in brown and green. That already gives a two-tone sukkah.

Fit

  • The lid has 0.35 mm of play on every rail face. If your printer runs tight and the lid binds, scale only the lid to 99.5 percent in X and Y.
  • Run the lid in and out a few times on the first fit to clear any stringing in the rails.